IMSS E3265
- 8 -
Sealing Unit To The Floor
After the unit is positioned and the leg levelers are turned out, the unit needs to be
sealed to the floor for NSF approved installation.
Base Panel Removal
IMSS60 and IMSS84 Panels
Panels must be in place when operating the case.
END PANEL
(ONE AT EACH END)
SIDE PANEL
SIDE PANEL
END PANEL SCREWS (4)
SIDE PANEL SLOT
SIDE PANEL HOOK
SIDE PANEL
RETAINER SCREWS
REMOVE THIS PANEL
TO CLEAN CONDENSER
Side Panels
1. Loosen the 2 retainer screws from top of panel.
(The screws will stay on the panel even after they are detached from base)
2. Tilt the top of the panel away from the base and pull up on panel to allow the
side panel tabs to pull out of the side panel slots.
3. Set the panel in safe place to prevent damage.
4. Reinstall panels in the reverse order.
End Panels
1. Remove the (4) retainer screws from all four corners of end panel.
2. Remove end panel from case and set it in safe place to prevent damage.
3. Reinstall panels in the reverse order.
IMSS120 Panels
DANGER: Electric shock hazard. Do not operate unit with panels removed.
DANGER: Electric shock hazard. Do not operate unit with panels removed.
