pressed and released, the YEAR will stop blinking and the MONTH will begin to blink.
Press and release the “ ” button until the desired month is reached.
See Figure 5.
Repeat this process to set the DAY, HOUR, MINUTES.
After you change the batteries, you have to readjust the date and time. Time is
maintained using a 24 HOUR clock. AM/PM is not displayed.
NOTE: When the number that you wish to set – i.e. YEAR, MONTH, DAY, HOUR,
MINUTE - is blinking, each time you press and release the “ ” button, the
number will increase by one. ***Time is displayed using a 24 hour clock. AM/PM
are not displayed.
Figure 5
For the unit change, you can select the mmHg or Kpa; and the mmHg is the definition unit.
When the machine is turned off, press the button “ON/OFF” more than about 10 seconds
till LCD blinks ,then press Memory button to switch between mmHg and Kpa .
Arm Cuff Connecting
★
The cuff should be snug but not too tight. You should be able to insert two fingers
between the cuff and your arm.
★
Place the cuff around the left bare arm ½” to ¾”’ above the elbow joint. The air tube
should be oriented to run down the center of the inside of your arm. (Refer to diagram on
cuff for proper placement. )
★
Keep the cuff at approximately the same level as your heart.
★
Unless your physician recommends otherwise, always use the left arm to measure
your blood pressure.
See Figure 6
★
Arm cuff connecting should make arm feel no much tension. Don’t connect too tense
(otherwise the measurement will be not precise).
