Fayat Dynapac CC1300, Instruction Manual

Page: 66 / 130

Miscellaneous
4812161001_J.pdf 2020-02-03
Load carrier Load carrier
- When loaded, the vibratory roller is centered laterally on the platform (± 5 cm). - When loaded, the vibratory roller is centered laterally on the platform (± 5 cm).
- The parking brake is applied and in good working condition, and the articulated joint lock is
closed. - The parking brake is applied and in good working condition, and the articulated joint lock is
closed.
- The drum is placed on a rubber liner, so that the static friction between the surfaces is at least
0.6. - The drum is placed on a rubber liner, so that the static friction between the surfaces is at least
0.6.
- The contact surfaces must be clean, wet or dry, and free from frost, ice and snow. - The contact surfaces must be clean, wet or dry, and free from frost, ice and snow.
- The lashing mounts on the load carrier have LC/MSL at least 2 tonnes. - The lashing mounts on the load carrier have LC/MSL at least 2 tonnes.
Lashings Lashings
- The lashings comprise a lashing strap or chain with a permitted load (LC/MSL) of at least 1.7
tonnes (1,700 daN) and a pre-tension S
TF
of at least 300 kg (300 daN). The lashings are
re-tightened as required.
- The lashings comprise a lashing strap or chain with a permitted load (LC/MSL) of at least 1.7
tonnes (1,700 daN) and a pre-tension S
TF
of at least 300 kg (300 daN). The lashings are
re-tightened as required.
- Each of lashings 1-4 is either a double or two single lashings. A double lashing runs in a sling
through a lashing point or around a machine part and down into two different mounts on the
platform. - Each of lashings 1-4 is either a double or two single lashings. A double lashing runs in a sling
through a lashing point or around a machine part and down into two different mounts on the
platform.
- Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
that are pulled in opposite directions may be placed in the same lashing mount, however. - Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
that are pulled in opposite directions may be placed in the same lashing mount, however.
- The lashings are as short as possible. - The lashings are as short as possible.
- The lashing hooks must not lose grip if the lashings become slack. - The lashing hooks must not lose grip if the lashings become slack.
- The lashings are protected against sharp edges and corners. - The lashings are protected against sharp edges and corners.
- The lashings are located symmetrically in pairs on the right and left sides. - The lashings are located symmetrically in pairs on the right and left sides.
Retractable ROPS (Optional)
Fig. Retractable ROPS
The machine can be equipped with retractable ROPS.
Risk of crush injury when raising and lowering
ROPS. Risk of crush injury when raising and lowering
ROPS.
If the roller is equipped with a retractable ROPS,
the machine must only be operated when it is lifted
up and locked. If the roller is equipped with a retractable ROPS,
the machine must only be operated when it is lifted
up and locked.
56