FATEK P5 Series, Connection Manual, Page: 147 / 224

147
Item Default Setting Remark
Signal Level Ethernet
Internet Protocol 192.168.0.1
Port 44818
Communication Method EtherNet/IP
2.7.2.2 PLC Resource Review
Device Description Data bit Input
format
Min. Max.
O Output File 1/16 O F:S.D O0:0.0 O0:30.255
I Intput File 1/16 I F:S.D I1:0.0 I1:30.255
S Status File 1/16 S F:E S2:0 S2:163
B Bit File 1/16 B F:E B3:0 B255:255
T Timer File 1/16 T F:E.D T4:0.0 T255:255.2
C Counter File 1/16 C F:E.D C5:0.0 C255:255.2
R Control File 1/16 R F:E.D R6:0.0 R255:255.2
N Integer File 1/16 N F:E N7:0 N255:255
F Floating File 32 F F:E F8:0 F255:255
A ASCII File 1/16 A F:E A9:0 A255:255
ST String File 1/16 ST F:E.D ST9:0.0 ST255:255.41
2.7.2.3 Connecting to HMI
The SLC series PLC can be configured using the same procedure as the Micrologix
series configuration. The figures refer to the Micrologix PLC but the procedure is the
same.
Configuring IP Address on PLC
If the IP address needs to be configured, follow the steps below.
Use the applications RSLinx Classic Lite and RSLogix 500 to configure the IP address of
the PLC.
First open RSLinx Classic Lite to set up a connection between the computer and PLC.
An Ethernet cable needs to be connected to the PLC and the computer must be online.
In the Communications menu tab, select Configure Drivers. Select EtherNet/IP Driver
and press ‘Add New’. Select “Your Network Interface Card” and press OK. Start the
Driver and close out of the dialog window.