CPC505
C P C 5 0 5 U s e r M a n u a l
56
© 2 0 2 2 F a s t w e l v . 0 0 1
A.5 Structure of I/O channels of RIO587
In RIO587-01 version, the rear panel is equipped with the following interfaces:
Table A-4
– Interfaces on rear panel of the RIO587-01 version
Interface
Quantity
Note
PS/2
1
Combined mouse/keyboard
USB 2.0
2
With support of HS, FS and LS speeds
Reset button
1
Reset (RST) button on the rear panel:
Initiates a
“cold restart” of the module (without turning
off the power).
Button is sunken which prevents accidental pressing;
Can be pressed using a long thin object.
Isolated Reset
1
Pins 4, 9 of the XP7 (COM5) connector, insulation 500V
GP Led
1
For operation description, please see section 3.4
RS-232
1
COM1, up to 1.5 Mbaud
RS-485
2
Isolated, 500 V. up to 460 Kbaud (COM5, 6)
LAN 10/100/1000 Mb
2
Use 2 x PCI-E x1 Gen2 channels
DVI-D
1
Resolution up to 1920
х1200@60 Hz
The top side of the module contains (see Figure A-4):
▪ CFast card slot (Compact Flash with SATA interface), SATA0 channel (XS5);
▪ SATA connector with Innodisk SATADOM support (Innodisk SATADOM is installed on the
RIO587-01 module), SATA1 channel (XP15);
▪ Power supply connector for HDD (XS8 (for RIO587-02 version);
▪ LPT connector (BH-26) per flat ribbon cable - IDC-26 (XS11);
▪ 3 x RS-232 connectors (BH-10) on flat ribbon cable - IDC-10 (XP10-XP12);
▪ 2 x connectors TH-4M for addi5V power supply to the CPC505 module;
▪ XP16 connector, to which the two-channel LVDS (XP16) is routed;
▪ BH-10 connector, to which GPIO0-GPIO7 lines and 3.3V power (XP5) are routed, see subsection
3.4 SPI Controller / LEDs / GPIO;
▪ PC Speaker (BF1).
The RIO587-02 module is provided with a mount for a 2.5
” hard disk drive (to be purchased
separately), which is connected to the SATA connector with a KIB587 adapter (included in the
delivery checklist).
