CPC505
C P C 5 0 5 U s e r M a n u a l
44
© 2 0 2 2 F a s t w e l v . 0 0 1
7. Using the front panel handles, extract the module from the backplane connector and carefully
remove it from the system.
4.4 Installation of the CPC505 peripheral devices
A wide variety of peripherals can be connected to the CPC505, and installation methods vary
widely. The following sections provide general installation guidelines only, not detailed algorithms.
4.4.1 Connection of USB devices
The CPC505 supports the use of any USB computer peripheral (e.g. keyboards, mice, printers
etc.).
Note
All USB devices can be plugged and unplugged when the power supply of the devices and master
system is ON.
4.4.2 Connecting devices to the Rear I/O Board
In order for the COM1-6 and Ethernet ports on the Rear I/O module to work properly, they must be
configured for use through the Rear I/O module using the BIOS Setup program.
Any details concerning installation of the devices that operate via Rear I/O please refer to the
relevant documentation.
4.5 Replacing the battery
In order to replace the lithium battery, use the same battery or the one recommended by the
manufacturer for replacement. Suitable models include Renata, Panasonic BR2032, or other
compatible models.
Important note:
Observe polarity when replacing the battery.
The battery should be replaced with an identical battery or the one recommended by the
manufacturer.
Dispose of the used battery in accordance with established regulations.
