58
Bit 6 Invert TTL Trigger. Setting this bit to 1 indicates the TTL trigger input on P2 is
active low level, or falling edge.
Bit 5 Enable TTL trigger. Set this bit to 1 to enable TTL trigger input on P2. Clear to 0 to
disable TTL trigger input.
Bit 4 Synchronous Exposure. This bit only affects free-run and multi-frame edge-
triggered modes. When this bit is set, the readout timing is synchronized to the exposure.
Bit 3 Invert Camera Link CC1 Trigger. Setting this bit to 1 indicates the CC1 trigger input
on Camera Link is active low level, or falling edge.
Bit 2 Enable Camera Link CC1 trigger. Set this bit to 1 to enable CC1 trigger input on
Camera Link. Clear to 0 to disable CC1 trigger input.
Bit 1:0 Trigger Mode.
0
Free-running mode.
1
Multi-frame edge-triggered mode.
2
Single edge-triggered mode.
3
External exposure mode.
0
X
43
T
RIGGER
C
OUNT
.
Total number of frames to capture in multi-frame edge-triggered mode. 0 to 255 program
0 to 255 frames.
0
X
44
CC
M
ODE
Enable and active edge of CC2, CC3, and CC4 command inputs. Bits 7, 6 are reserved.
Other bits are:
Bit 5 Invert CC4. Setting this bit to 1 indicates the CC4 input is active on falling edge.
Setting this bit to 0 indicates the CC4 input is active on rising edge.
Bit 4 Enable Camera Link CC4. Set this bit to 1 to enable CC4 Sensor Calibration.
When enabled, the active edge of CC4 causes the sensor to be reset and calibrated at the
next appropriate time.
Bit 3 Invert CC3. Setting this bit to 1 indicates the CC3 input is active on falling edge.
Setting this bit to 0 indicates the CC3 input is active on rising edge.
Bit 2 Enable Camera Link CC3. Set this bit to 1 to enable CC3 Reset Memory. When
enabled, the active edge of CC3 causes the memory to be reset.
