Fastcorp FRI-Z400, Installation & Setup Manual

Page: 27 / 46

Display Programming Instructions
4) CREATE SELECTION a) Press the #=Yes key to enter create selection menu.
*=Next D-Back
#=Yes
Enter Selection b) Enter the selection number you wish to create.
#_ _
*=Exit
Enter Selection #A1 c) Press the #=Yes key to enter the selection number.
Create? *=No
#=Yes
A1 Price: $0.00 d) Type in the price and press the enter key.
*=Abort
#=Enter
A1 Price: $1.50 e) Press the #=Yes key to enter the price.
Accept? *=No
#=Yes
A1 Height: 1 inch (1-4 inches) f) Press the *=Next key until you have selected the height
of the product, then press the #=Accept key. If you have
selected the proper product height the robot will leave one
product at the bottom of the bin for the route driver to
match the products when filling the machine.
*=Next
#=Accept
A1 Height: 2 inches g) Press the #=Yes key to enter the product’s Height.
Accept? *=No #=Yes
A1 Program Bin h) Press the #=Enter key to create a bin for the selection
number.
*=Abort #=Enter
A1 Move Robot i) Use the directional buttons on the Service Keypad and
move the robot over the center of the product/bin you have
selected. Hold the button down to accelerate or pulse your
finger on the button to move in 1/16” increments. Move the
robot back and then drop the picker head to verify that it is
centered over the bin. Press the #=Accept key on the cus-
tomer keypad to store the location of bin 1.
*=Cancel #=Accept
1 Bin Height: Short (Tall) j) Press the *=Next key to see Bin Heights. Press the
#=Accept key to enter Bin Height.
*=Next #=Accept
A1 More Bins? k) Press the *=No key if only one bin is being programmed.
The programming for that selection is complete. Simply re-
peat this process with another selection number. Press the
#=Yes key if two or more bins are needed for that selection
number. A total of four bins per one selection number are
available.
* =No #=Yes
A1 Program Bin #2? l) Press the #=Enter key to program a second bin for the
selection number.
*=Abort
#=Enter
A1 Move Robot m) Move the robot to the second bin. Press the #=Accept
key to enter second bin location.
*=Cancel
#=Accept
A1 Bin Height: Tall (Short) n) Look inside freezer and verify if the bin is tall or short.
Press the #=Accept key to enter bin height.
*=Next
#=Accept
Program Bin 3?
*=No #=Yes
o) Enter selection.
4) CREATE SELECTION:
Create up to eighteen brand new selections, with 1-4 bins per selection.
A-23