Fastbind PUREVa Xt UsER manUal | v 1.0 | © maping Co 2014
18
DRAFT
beFore draInIng
•
place a gray board (chip board)on the
positioning deck, the rear edge against the back
support.
•
put a stack of papers (approximately 4 cm/ 1.5”
thick) on the position deck in portrait position
(the short edge against the deck). close the
clamp and turn the table to gluing position.
•
the glue has to be melted before the glue
cartridge can be drained. use the pur
temperature setting for pur -glue and the eVa
setting for eVa -glue.
11. draInInG THe Glue carTrIdGe
11. draInInG tHE GLuE cartrIdGE
Figure 10-x X
draInIng tHe pur glue cartrIdge
•
cover the book block spine with gray board
so that the long edge of the board is towards
you (the long edge is parallel with the glue
applicator rail).
•
Move the heating dock sideways close to the
book block by using the applicator handle.
Move the gray board against the back wall
of the glue cartridge docking station. apply a
sufficient amount of glue on the gray board by
moving the unit back and forth from applicator
handle.
•
stop the heating dock in the middle of the paper
block. remove the gray board by pulling it
towards yourself, throw out the greyboard. Move
the heating dock right over the edge of the
paper block.
•
repeat the steps until the glue roller stops
applying glue on the gray board and it is empty,
add a small amount of eVa glue and repeat
twice.
•
leave a small amount of eVa glue in the
cartridge.
