Fast BW500, Operation And Maintenance Manual

Page: 62 / 112

Filling The Product Tank
Page 56
HYDRAULIC DRIVE PUMP (OPTIONAL)
8. Dispose of all captured chemicals
properly.
CAUTION: Prevent serious injury
or death.
Check chemical or fertilizer M/SDS for
proper handling instructions.
Toxic chemicals can enter the body by
breathing spray or contact with bare skin.
Do not take a chance with your health and
safety.
IMPORTANT: Transport machine with
tank EMPTY to prevent machine dam-
age.
NOTE: Add only the amount of liquid to
the tank that is required for the job.
Filling The Product Tank
NOTE: All poly tanks are not identical in
capacity due to different tank molds, heat
and/or cold. Tank sizes can and do vary. It
is recommended that you measure by an
independent means the amount of liquid
being loaded.The sprayer can be
equipped in one of three ways:
• No fast fill attachment - Standard
configuration
• 2” Fast Fill via transfer pump - Optional
(Group A)
• 2” Fast Fill via transfer pump or sprayer
pump - Optional (Group C)
NOTE: If Group C is ordered, you have
the option of manual or Electric controls
for the rinse system.
Refer to the appropriate set of instructions
that follows, depending on your sprayers
configuration.
Fill Through Top Lid (Standard Configu-
ration)
1. Remove the lid from the top of the
product tank. Fill the tank using a garden
hose or similar means.
2. Replace the lid when complete.
Filling With Transfer Pump
Your sprayer is equipped with a 2” male
fast fill connector and a ON/OFF valve
(identified as “Valve F”) located on the left
side of the sprayer, directly behind the
step.
Fill as follows:
1. Connect the fill hose to the 2”
connector.
2. Charge the fill hose with water using the
transfer pump.
If Equipped With Manual Control Rinse
System:
• Turn the manual three way ball valve
identified as “Valve E” (located under the
platform on left side of sprayer) to “Product
Tank” (handle pointed toward rear of
sprayer).