Fast BW500, Operation And Maintenance Manual

Page: 48 / 112

TeeJet Controller (Standard)
Page 42
HYDRAULIC DRIVE PUMP (OPTIONAL)
HYDRAULIC DRIVE PUMP (OPTIONAL)
Hydraulic Hose Hook Up:
WARNING
Hydraulic oil under pressure can spray
into eyes and cause physical injury.
Follow tractor operator manual instruc-
tions for shutting off hydraulic supply
and relieving hydraulic pressure before
connecting or disconnecting hydraulic
hoses.
Assemble the sprayer hydraulic pump
hoses to the tractor hydraulic couplers.
IMPORTANT: Assemble the hoses to the
tractor, but DO NOT activate hydraulics
until the pump has been properly primed.
2. Place the tractor hydraulic control lever
in the position next to the float position.
The pump should operate. If the pump
does not operate, place the tractor hydrau-
lic control lever in the float position.
3. Disconnect and reverse the sprayer
hose connections at the tractor. The pump
should operate.
IMPORTANT: Always use the float posi-
tion to STOP the hydraulic sprayer pump.
NOTE: If sprayer is being hitched to the
tractor for the first time, charge the sprayer
hydraulic system with oil.
IMPORTANT: The storage slots for the
hydraulic hoses should ONLY be used
when sprayer is disconnected from the
tractor and being stored. Hydraulic hoses
MUST always be connected to tractor
during transport of sprayer.
Control Box Installation
Electrical Connections To Tractor
When connecting the electrical control
boxes to the tractor, it is recommended
that you purchase a wiring harness pigtail
adaptor from your tractor dealer or your
Fast dealer.
Be sure to ONLY connect to tractors with a
12 Volt Positive electrical system.
Electric Sprayer Controls
NOTE:
Refer to the separate control box
owner’s manual for detailed installation
instructions.
1. Turn OFF all switches.
2.Install control box in the tractor cab in a
location where it can be used easily and is
readily visible.
3.Determine best routing for control cable
and pressure tube. Be sure the cables
and/or tubes DO NOT interfere with any
moving parts on tractor or sprayer.
4.Install Mounting bracket.
5.Make tractor connections for power
input, ground and pressure tubing if so
equipped.
TeeJet Controller (Standard)
a.Connect the 2 RED wires to the 12 volt
power source (positive).
b.Connect the 2 BLACK wires to a ground
point on the tractor (negative).
c.Connect the single BLUE wire to the
tractor headlight system. The BLUE wire
powers the light in the pressure gauge and