11
Step 3:
Mount Fuel System
a. Using thread tape, install the 10-298 into “E” and the 10-299 into the “T” port (on opposite end).
b. Attach BR-2001 to back of system using 5 1 1/4” Hex bolts and WA-2001
spacers. Torque to 110in/lbs.
c. Placing the WA-1001C‟s between the FB-2001 & the BR-2001, assemble
the FASS pump brackets together. Hold pump up to the mounting location
for rough fitting. Once location is established, use template on back of man-
ual to accurately mark drill points. As seen in next step.
d. Position the pump assembly at the mounting location (emergency brake
cable bracket) check for fit. Once location is established,
use template lo-
cated on the contents page to accurately mark drill points
.
e. Pre-drill holes. Final drill with 3/8” bit. Mount pump, level, tighten all
bolts.
f. Apply motor oil to gasket located on filters. Attach to system and hand
tighten.
Note - Before Mounting in Position:
Route wire harness along frame rail to
mounting location. Plug female plug of the FASS harness into pump. Turn key
on. With pump operating, liberally spray WD-40 (or equivalent) into „T‟ port
lubricating gear.
Summary of Contents for Titanium Series
Page 6: ...7 BR 2001 WH 1001 MP 9023 FL 1001 x15 FB 2001 Contents...
Page 13: ...14...
