Faro EVA, User Manual, Page: 9 / 14

EVA USER MANUAL - EN
Edition 1.0 April 2020 Pag. 9 di 14
4.9 SYNCRO MODE WITH FARO ROOM LIGHT
When present, the device can be connected by Radio Frequency (RF) connection to the Faro Room Light to
create a synchronized lighting system.
The procedure to create this connection is called “pairing”.
If more than one Room Lights are installed in the cabinet, take care that the other Room Lights are turned
off or are turned on for more than 60 seconds.
To activate the
“Pairing”
, proceed as follows:
1. Switch on the Faro Room Light. The Room Light will start Searching an input from the dental light for 60
seconds.
2. Within the 60 seconds, press the “Pairing” button on the dental lamp between 4 and 6 seconds. But not
for more than 6 seconds ( otherwise the procedure will be cancelled).
The Room Light activates the blue LED on the aluminium body.
If the blue LED does not switches on, it is possible another attempt (within the 60 seconds by
the firsts). If 60 seconds past from the switching on of the Room Light, it is necessary to repeat
the procedure from point 1.
3. After the blue LED switches on the room light, there are 60 seconds to confirm the
“Pairing”
by pressing
the programming button placed on the remote control of the Room Light. At this point, the blue LED of the
Room Light blinks at double frequency and then switches off. If the button on the remote controls is not
pressed within 60 seconds, the blue LED switch off and the procedure must be repeated from point 1.
After the
“Pairing”,
synchronization between the 2 lamps (dental light and room light) is enabled.
To
DE-ACTIVATE THE SYNCHRONIZATION FUNCTION
, proceed as follows:
Press the Synchro button from 2 to 4 second, then release it.
On release, a sound signal (Beep) will be heard and the blue LED on the Room Light lamp will go out to
indicate that synchronization has been disabled.
When the Faro Room Light is synchronized with the Dental Light the blue LED on the room light is lighted in steady mode. If the LED is off, the
synchronization is not active.
The remote control is always enabled, so it is possible to change the illumination value in manual mode.
If the Dental Light is turned off, the room light will remain switched.