9
Revision date: 01.13.21
113539
3
Assembly Instructions
1. Using the assembled frame as a bench, place one 8'
channel (113533) on the cross supports.
2. Using the 112509 adhesive, attach the plain end cap (no
outlet–111127) to the end of the channel that is resting
on the high side of the support table. This is the end with
the 36" legs. Be sure to coat the end of the channel with
adhesive
before
you install the end cap. Repeat for all 8'
channels.
3. Move to the other end of the channel and install the 111128
end cap (with outlet). Coat the end of the channel with
adhesive
before
you install the end cap. Repeat for all
channels.
4. Next, attach a 90° elbow (WF6682) to each 111128 end cap
as shown. Apply pvc primer and pvc cement (WF6990) to
end cap outlet and inside fitting and slide fitting onto outlet.
Install fitting as shown with open end pointing down in the
6:00 o'clock position.
ATTENTION:
Verify that you are using the WF6682 elbows.
These are without threads.
Do not use the WF6692 elbow.
ASSEMBLE ALL 8' 113533 CHANNELS
5. Once all end caps and drain elbows are in place, carefully
flip all channels over so the bottom is facing up and the open
top is down.
6. Apply the 112509 adhesive along the edges to secure end
caps to each 8' channel. Photos show an end cap with an
outlet. Secure the plain end caps in the same manner.
NOTE:
Be sure to coat all edges and seams of the end caps
to prevent leaks.
7. Allow the adhesive to dry before moving the channels or
testing the system.
8. Continue with the next procedure.
Apply primer and cement in a well-ventilated area. Read and
follow container information for additional precautions.
A
B
C
D
G
WF6682
Elbow
113533 Channel (8')
WF6682
Elbow
open
top-inside
channel
bottom
E
F
H
WF6990
PVC Cement
& 113372
Primer
