21
Revision date: 01.13.21
113539
14
Assembly Instructions
1. Determine the desired 1/4" tube length. Tube should reach
from the grommet in the supply manifold to a hole in the
channel lid immediately above the grommet.
2. Adjust tube length if needed and cut remaining tubes from
the 111046 tube. Use the plastic pipe and tube cutter to
create a clean, smooth cut.
3. Once all tubes are cut, slide one into each grommet.
Wet the tube end for easier installation. To ensure 1/4"
feeder tube is fully inserted into top hat grommet of supply
manifold, mark a line on tube end opposite beveled end that
CUT AND INSTALL THE SUPPLY TUBES
c. Slide one tube into each of the
supply manifold grommets.
a. Cut the 16" supply tubes from the
111046 poly tubing.
b. Mark tube for depth of insertion
into grommet.
d. Slide lid back onto channel. Install
tubes in holes.
Cut tube end
at an angle.
is 1/2" in from end. Tubes can be marked individually, or aligned and marked using a straight edge to save
time.
4. Insert two tubes into a channel lid at each location.
Trim the end of each tube at an angle for easier
installation.
5. Continue by connecting the air circulation pump.
