ASSEMBLY AND MOUNTING
CH 140 CHIPPER
www.farmiforest.fi
--- 17 ---
5.TRAFFIC ON PUBLIC ROADS
IMPORTANT!
Prior to every procedure
always recall the general
safety instructions given in
chapter 3.
Follow these special instructions to
avoid risks of accidents. Otherwise the
manufacturer or retailer will not
assume any liability for damage.
You shall have full control of the unit in
every situation when driving.
Bumpy driving might damage the
chipper / the feeding device.
Always
follow
the
regulations
established by the law.
5.1.TRANSPORT POSITION
1. Open the pawl lever of the feed chute and
turn the chute aside. Disconnect one end of
the control lever from the valve and lock the
chute into transport position.
2. Turn the discharge chute into transport
position.
3. Before driving off, ensure the machine unit’s
appropriate stability and check that the
chipper is firmly connected to the tractor and
all fasteners are in place.
IMPORTANT!
Make sure that the rear
lights of the tractor are
visible. Use a separate light
panel, if needed.
6.PREPARATIONS FOR START
UP
Do not attempt to operate
this
chipper
without
proper training. Read and
understand the owner’s
manual before operating
the machine.
WARNING
!
Failure to heed the warnings printed on
the chipper or in the operators manual
might result in serious injury or death!
6.1.LIFTING
IMPORTANT!
Prior to every procedure
always recall the general
safety instructions given in
chapter 3.
Make sure that nobody will
enter the lifting zone.
DANGER!
Always
check
before
lifting that the lifting
equipment is in order and
use the marked lifting
points,
whenever
possible.
Always
use
proper lifting equipment
and check for its sufficient
lifting capacity.
CAUTION!
Know the weight of the load and check
that the performance of the lifting
equipment will not be exceeded.
Check the hoisting cables and chains
regularly. Mark any discarded cable
and remove it immediately.
