22
│
25
Manual
KULTIS 6 | KULTIS 8
ground and thus make the working unit lighter. Place the spacers on the piston-rods of the
rear travelling wheels to maintain the proper working depth.
Fig. 12 Chassis Piston-rod Spacers
The spacers are located in the rear part of the machine on the ladder railing.
5. Open the pressure oil inlet valve.
Fig. 13 Hydraulic Pressure Valve in Open Position
6. Using the control of the external hydraulic circuit, set the pressure in the system to the
basic setting value: 60bar.
When turning the machine at the headland and using the levers of the external and internal
circuit of the tractor hydraulics at the same time, the machine is rearranged into the transport
position and thus can be turned around.
The down pressure may be changed continuously during operation depending on the soil
conditions by using the controls of the external circuit of the tractor hydraulics; however, not more
than 100bar.
The working depth of the machine should be within the range of 5
– 8cm.
The working speed of the machine should be within the range of 5
– 10km/h.
Various soil conditions will require a change in the machine setting. Always follow the basic
setting and observe the instructions to ensure a proper function of the machine.
