Manual KOMPAKTOMAT K400NS
18
Chart 6
–
Places and intervals of lubrication
PLACE FOR LUBRICATION
INTERVAL
LUBRICANT
Controlling handle
Picture 12
-Daily, when working on the field.
-Always before work with the machine.
-Always after the work and before putting the
machine out of operation.
-Plastic lubricant
-*Plastic lubricant based
on lithium
*Rear roller bearings
Picture 13
*Front roller bearings
Picture 14
Picture 12
–
Lubricating the controlling handle
Picture 13
–
Lubricating the rear roller bearings
Picture 14
–
Lubricating the front roller bearings
MANIPULATION WITH LUBRICANTS:
Treat oils and lubricants as hazardous waste according to valid regulations and acts.
Protect yourself from direct contact with oils by using gloves or protective lotion.
Wash oil stains on skin thoroughly with warm water and soap. Do not clean the skin with petrol, diesel oil
or other dissolving agents.
Oil or lubricant is poisonous. If you swallow any, immediately seek a doctor.
Keep oil and lubricants out of reach of children.
6.2
REPLACEMENT OF WORN SHARES
Always observe the safety regulations and instructions when replacing shares.
The machine must be aggregated with the tractor according to chapter 3.1/p.11 when shares are replaced. The
tractor must be turned off and the operator or repairer must prevent free access of unauthorized persons to the
tractor.
Replace the shares on solid and even surface and when the machine is standing still.
If the hydraulic system of the tractor is not tight, you have to provide mechanical supports for the machine
pole.
6.2.1
REPLACEMENT OF WORN SHARES ON THE SIDE FRAMES
Put the machine into the transport position according to Item 3.3.1/p.12, including the protection of the side
frames.
Replace the shares you can reach.
*
*
