Farmet K Series, Operating Manual

Page: 10 / 23

Manual KOMPAKTOMAT K400NS
10
1.2
HYDRAULICS OF THE MACHINE
It is forbidden to disassemble the parts of the hydraulic system that are under pressure.
Hydraulic oil that penetrates skin under high pressure causes serious injuries. In case of an injury
immediately seek medical help.
Hydraulic scheme K400NS
2. ASSEMBLY OF THE MACH
INE AT THE CUSTOMER’
S
SITE

The operator
must execute the assembly according to the producer’s instructions, if poss
ible in
cooperation with a professional service technician determined by the producer.

The operator must execute a functional test of all assembled parts after the completion of the assembly of
the machine.

The operator must ensure that the manipulation with the machine by lifting equipment corresponds with
Chapter “ C”
.
3. PUTTING INTO OPERATION

Before you take over the machine, test and check it for any damages incurred during transportation and
check that all parts included in the delivery note have been delivered.

Before you put the machine into operation, read the operating manual carefully, particularly chapters A-D
p.4-8. Learn about the control elements of the machine and its overall function before the first use.

When working with the machine, observe the instructions in the manual as well as generally valid rules
for the safety at work, protection of health, fire and traffic safety and protection of environment.

The operator must check the machine before every use (putting into operation) for aspects in the field of
completeness, safety at work, work hygiene, fire safety, traffic safety and protection of environment.
 IF THE MACHINE SHOWS SIGNS OF DAMAGE, IT MUST NOT BE PUT INTO
OPERATION!!
 Execute aggregation of the machine with the tractor on an even and compact surface.

When working on slopes, observe the lowest slope accessibility of the whole set TRACTOR
–
MACHINE.
 Before turning on the engine of the tractor, check that there are no people or animals in the working area
of the set and press the warning sound signal.

The operator is responsible for safety and for all damages caused by the operation of the tractor and the
attached machine.
 The operator must observe technical and safety regulations of the machine determined by the producer
when working with the machine.

The operator must raise the machine when turning at the plough turning end, i.e. the working parts must
not be in the ground.
 The operator must observe the prescribed working depths and speeds set in the operating manual in Chart
2/p.4 when working with the machine.

The operator must lower the machine to the ground and secure the set against movement before leaving
the cabin of the tractor.
1- Controlling distributor in the tractor
2- Hydraulic snap couplings
5- Hydraulic cylinder of side frame unfolding
6- Hydraulic closing valve of the cylinder for side frame
unfolding