36
|
41
13 MACHINE STORAGE
Long-term machine shutdown:
•
Store the machine on a flat and solid surface with sufficient load capacity.
•
Clean the machine before storing and conserve so that it is not damaged in any way during
storage. Pay special attention to all marked lubrication points and properly lubricate them
according to the lubrication plan.
Machine Shutdown Procedure
1.
Eject the roller piston rods to the maximum position, hose marked with
2.
Check that the pressure shown on the pressure gauge of the ploughshare protection circuit is 90 bar;
if so, close both ball valves, see Fig. 10.
3.
Depressurize the supply hoses for the hydraulic circuits of the machine.
4.
Check that the pressure in the ploughshare protection circuit shown on the pressure gauges of the
machine has not decreased.
5.
Disconnect the hydraulic hoses of the machine from the tractor distributor.
6.
Place the machine on a flat and firm ground so that it is resting on the rear roller and share beams.
Use a suitable support for the share beams (such as scantlings) so that the points of the chisels are
above the ground, see Fig. 10. If you do not have a suitable support, disassemble the chisels.
Fig. 10 - machine put out of operation correctly
A - The rests
Summary of Contents for DIGGER 3 N
Page 2: ...2 41 Prepared by Technical Department Farmet a s on 12 10 2018 changes reserved ...
Page 4: ...PREFACE 4 41 IMPORTANT READ CAREFULLY BEFORE USE KEEP FOR FUTURE REFERENCE ...
Page 6: ...PREFACE 6 41 ...
Page 15: ...WORK SAFETY LABELS Fig 1 Location of safety labels on the machine 15 41 ...
