26
|
41
10 MACHINE ADJUSTMENT
•
The working parts of the machine can be adjusted by the operator only when the machine is
idle, i.e. not working and secured against movement.
1 – TPS – setting of the longitudinal level
2 – Manometers – ploughshare protection pressure
3 – Piston rod – setting of the working depth and disc position
4 – Handles – setting of the disc position
5 – Nut – setting of the roller inclination
6 – Height-adjustable wings
7 – Edge discs – width-adjustable
10.1 Adjusting the working depth of the machine
•
The working depth is set by means of washers on the piston rods of the rear roller.
•
12 mm thick washers are used for setting the depth, where one washer changes the depth by
25 mm.
•
For the required embedding of the machine, the individual combinations of the spacer washers
are provided in Fig. 5.
•
The working depths mentioned below are only approximate and can differ depending on the
given soil conditions.
Summary of Contents for DIGGER 3 N
Page 2: ...2 41 Prepared by Technical Department Farmet a s on 12 10 2018 changes reserved ...
Page 4: ...PREFACE 4 41 IMPORTANT READ CAREFULLY BEFORE USE KEEP FOR FUTURE REFERENCE ...
Page 6: ...PREFACE 6 41 ...
Page 15: ...WORK SAFETY LABELS Fig 1 Location of safety labels on the machine 15 41 ...
