Farm King Allied 80 Series, Operator And Parts Manual

Page: 37 / 62

Maintenance - 80 Series Rear Blade
35
LUBRICATION
Recommendations
Always use a good quality multi-purpose / lithium
base grease when lubricating the equipment.
• Always use a hand-held grease gun.
• Clean fitting before greasing, to avoid injecting dirt
and grit.
• Replace and repair broken fittings immediately.
• If fittings will not take grease, remove and clean
thoroughly. Replace fitting if necessary.
WARNING
AVOID INJURY OR DEATH
Stop engine, set brake, remove ignition key, and
wait for all moving parts to stop before servicing,
adjusting, repairing, or unplugging.
Support the equipment with blocks or safety
stands before working beneath it.
Follow good shop practices:
• Keep service area clean and dry
• Be sure electrical outlets and tools are properly
grounded
• Use adequate light for the job
Use only tools, jacks, and hoists of sufficient
capacity for the job.
Replace and secure all shields removed during
servicing before operating.
Use heavy leather gloves to handle sharp objects.
Check hydraulics regularly for leaks. Use
cardboard to look for leaks, and use hand and eye
protection.
Relieve pressure on hydraulic system before
repairing or adjusting.
Locations
IMPORTANT
Fluid such as engine oil, hydraulic fluid,
coolants, grease, etc. must be disposed of in an
environmentally safe manner. Some regulations
require that certain spills and leaks on the ground
must be cleaned in a specific manner. See local,
state and federal regulations for the correct
disposal.
Figure 13
Apply two to three pumps of grease to the
following locations
[Figure 11] :
• Hitch bushing (Item 1)
• Arm bushing (Item 2)
• Blade bushing (Item 3)
Grease daily (or every 8 hours of use).
1
2
3
2-3