Farm King 1342, Operator And Parts Manual, Page: 56 / 194

Assembly - 13” Conventional Auger
52
MOUNT - PTO BEL T
Mount - PTO Belt - 1342 Models
Figure 71
Position the cross brace (Item 1) between the
undercarriage weldments. Attach the cross brace
to the mounts using eight 3/8" x 1" hex bolts, eight
3/8" flat washers, and eight 3/8" lock nuts (Item 2)
[Figure 71] .
Figure 72
Position the PTO drive mount (Item 1) on the cross
brace. Attach two plates (Item 2) on the inside of
the mount, and around the cross brace
[Figure 72] .
See [Figure 69] to install mount.
Position the plate (Item 3) on the side of the mount.
Attach using four 3/8" x 1" hex bolts and four 3/8"
lock nuts
[Figure 72] .
Align two pillow bearings (Item 4) with the side
plate and holes on top of the mount. Attach each
pillow bearing using two 1/2" x 2" hex bolts, two
1/2" flat washers, and two 1/2" lock nuts
[Figure
72]
.
Slide the PTO shaft (Item 5) through the side plate
and pillow bearings. Tighten bearings
[Figure 72] .
Place the PTO shield (Item 6) over the shaft and
bearings. Attach the shield to the mount using
four 3/8" x 1" hex bolts, four 3/8" flat washers, and
four 3/8" lock nuts
[Figure 72] .
1
3
6
4
1
4
2
5
2
DISCHARGE