Farm King 1342, Operator And Parts Manual, Page: 40 / 194

Assembly - 13” Conventional Auger
36
BRIDGING - C1362 MODELS
Figure 29
Position the bridging yoke (Item 1) on the tube
mount. Attach using two 5/8" x 2" hex bolts (Item
2) and two 5/8" lock nuts
[Figure 29] .
Position the brace (Item 3) within the yoke. Attach
using two 7/16" x 1-1/2" hex bolts and two 7/16"
lock nuts
[Figure 29] .
Place two cables (Item 5) along the length of the
tube
[Figure 29] .
Figure 30
Attach the mid-section of each cable to the yoke
using one 1/2" clamp (Item 1), two 1" X 7/16" flat
washers, and clamp nuts
[Figure 30]
.
Figure 31
Connect the cable (Item 1) to the eye-bolt (Item 2)
[Figure 31] .
Attach the eye-bolt to the mount on the intake tube
using one lock nut (Item 3)
[Figure 31] .
Only tighten the nut past the first few threads of
the eye-bolt to leave room for tightening.
Repeat on other side.
Figure 32
Connect the cable (Item 1) to the bracket (Item 2)
[Figure 32] .
Pull the cable to remove slack.
Attach the bracket to the mount on the discharge
tube using hex bolt and lock nut (Item 3). Use an
appropriate hole on the bracket to remove the
most slack in the cable
[Figure 32] .
Repeat on other side.
2
1
1
2
3
1
1
2
3
4
3
5
DISCHARGE TUBE
INTAKE TUBE