DTC4500e_User Guide_EN, PLT-01669, Rev. 1.1
April 2014
Page 19
2
Setup and Installation Procedures
This section describes the setup and installation for the DTC4500e Card Printer.
2.1
Choosing a Good Location
The following guidelines help to ensure optimal printing performance:
Place the unit in a location with adequate air circulation to prevent internal heat buildup.
Use the printer's dimensions as a guideline for the minimum clearances to the unit.
Note:
Allow for adequate clearance in front of the unit to accommodate the unit with its covers open.
Do not install unit near heat sources such as radiators or air ducts or in a place subject to direct
sunlight, excessive dust, mechanical vibration or shock.
2.1.1
About Moisture Condensation
If the unit is brought directly from a cold to a warm location or is placed in a very damp room,
moisture may condense inside the unit. Should this occur, print quality may not be optimal.
Leave the unit unplugged in a warm, dry room for several hours before using to evaporate any
moisture.
Caution: For safety purposes, Ethernet is not intended for a direct connection outside of the
building.
Attention: Pour des raisons de sécurité, Ethernet n'est pas conçu pour une connexion directe
à l'extérieur du bâtiment.
2.2
Unpacking and Inspection
While unpacking your Printer, inspect the carton to ensure that no damage has occurred during
shipping. Make sure that all supplied accessories are included with your unit.
Check that the following items are included:
•
Power Supply
•
US/EU Power Cable
•
USB cable (2.0)
•
Software Installation CD
•
Card Printer User Guide
•
Warranty Statement, Compliancy Document
