DTC4500e_User Guide_EN, PLT-01669, Rev. 1.1
April 2014
Page 81
Error Message
Cause
Solution
# 8
Head Sensor Error
The printhead temperature
sensor is not functioning or is
not connected properly.
Or, the printhead is not cooling
properly.
Reset the printer and try again.
If the problem persists, call for
technical assistance.
# 9
Reboot Required
An unspecified system error has
been detected by the printer
firmware.
Reset the printer and try again.
If this problem persists, call for
technical assistance.
# 25
Ribbon not Installed
No ribbon is installed in the
printer.
Install a ribbon and retry.
# 30
Mag Verify Error
Magnetic encoding verification
has failed.
Try encoding with a different card.
Verify cards have the magnetic
stripe.
Replace the magnetic encoding
module.
# 31
No Mag Module
The printer is not configured with
the encoder data type that you
are trying to send.
Ensure that no encoding data is
being sent with the print job and
reprint the card.
Install a magnetic encoding
module.
# 38
# 39
# 40
EEPROM Corrupt
EEPROM Read Error
EEPROM is restored with
factory default values.
If changes were made in the
Advanced Settings tab in the
printer driver, click the Default
button to reset these numbers.
Reset the printer and try again. If
this problem persists, call for
technical assistance.
# 44
Flipper Jam/ Home
Error
A card has become jammed in
the printer’s flipper table.
The flipper failed to position
properly while aligning a card or
flipping a card.
Clear any cards in the flipper table
using the buttons to move the
card out. Resume printing.
The flipper table should be level
when the printer is powered up. If
the flipper Table is at an angle,
open the card output door and
manually level it. Then cycle the
printer power to reset.
Reset the printer and retry. If
problem persists call for technical
assistance.
