28
provider.
The device is default configured in DHCP mode.
There are three common IP configuration modes about IPv6
DHCP - This is the automatic configuration mode by getting network configurations from a DHCP server.
Users need not to configure any parameters manually. All configuration parameters will be getting from
DHCP server and applied to the device. This is recommended for most users.
Static IP configuration - this option allows users to manually configure each IP parameter, including IP
address, mask, gateway, and primary and secondary domains. This usually applies to some
professional network user environments.
Please see 10.7.2.1 network Settings for detailed configuration and use.
7.7 SIP Configurations
A line must be configured properly to be able to provide telephony service. The line configuration is like a
virtualized SIM card. Just like a SIM card on a mobile phone, it stores the service provider and the account
information used for registration and authentication. When the device is applied with the configuration, it will
register the device to the service provider with the server’s address and user’s authentication as stored in the
configurations.
The user can conduct line configuration on the interface of the phone or the webpage, and input the
corresponding information at the registered address, registered user name, registered password and SIP
user, display name and registered port respectively, which are provided by the SIP server administrator.
Phone interface: To manually configure a line, the user can press the line key for a long time, or press the
button in the function menu [
Menu
] >> [
Advanced Settings
] >> [
Accounts
] >> [
Line 1
] / [
Line 2
]
configuration, click OK to save the configuration.
NOTICE! User must enter correct PIN code to be able to advanced settings to edit line configuration.
(The default PIN is 123)
The parameters and screens are listed in below pictures.
Picture 10 - Phone line SIP address and account information
WEB interface: After logging into the phone page, enter [
Line
] >> [
SIP
] and select
SIP1/SIP2
for
configuration, click apply to complete registration after configuration, as shown below:
Summary of Contents for X1S
Page 1: ...User Manual X1S X1SP ...
