[
键入文字
]
38
/ 54
c)
MCAST
It is easy and convenient to use multicast function to send notice to each member of the multicast via
setting the multicast key on the device and sending multicast RTP stream to pre-configured multicast
address. By configuring monitoring multicast address on the device, the device monitors and plays the
RTP stream which sent by the multicast address.
MCAST Settings
Equipment can be set up to monitor up to 10 different multicast addresses, used to receive the
multicast RTP stream sent by the multicast address.
Here are the ways to change equipment receiving multicast RTP stream processing mode in the web
interface: set the ordinary priority and enable page priority.
Priority:
In the drop-down box to choose priority of ordinary calls, if the priority of the incoming streams of
multicast RTP, lower precedence than the current common calls, device would automatically ignore the
group RTP streams. If the priority of the incoming stream of multicast RTP is higher than the current
common calls priority, device would automatically receive the group RTP streams, and keep the current
common calls in maintained status. You can also choose to disable the function in the receiving threshold
drop-down box, the device would automatically ignore all local network multicast RTP streams.
The options are as follows:
1-10: To definite the priority of the common calls, 1 is the top level while 10 is the lowest
Disable: ignore all incoming multicast RTP streams
Enable the page priority:
Summary of Contents for i30
Page 1: ... 键入文字 i30 IP Video Door Phone User Manual V3 0 ...
Page 16: ... 键入文字 16 54 e Auto Provision ...
Page 24: ... 键入文字 24 54 ...
