4.
If inserting a silica gel pack inside the housing in order to prevent moisture, it is best to insert it
on the left side of the camera,
mounts, where it doesn’t interfere with proper housing operation. It is important to make sure
that the silica gel pack doesn’t stick out, or else it might interfere with the water
housing.
5.
If making use of the Vacuum System, make sure it is fully charged and turn it on prior to closing
the housing (see section “Hybrid Vacuum Safety System”).
CLOSING THE HOUSING
1.
Turn the housing Control Dial till the
shooting mode symbol is positioned at the
left (image #15). Make sure not to accidently
turn this control any further before closing
the housing.
2.
If making use of the Hybrid Vacuum Safety
System, turn the vacuum system on using the power switch on the Signal Board prior to closing
the housing (see section “Hybrid Vacuum Safety System”).
3.
Turn the latch dial so that the small red tab located on
of the housing (image #16).
4.
Carefully close the back door of the housing, pushing it against the front door
there is nothing sticking out of the housing or impairing the smooth closure of the back door
Then firmly press the back door against the forward section of the housing.
5.
Turn the secure dial clockwise till the lock dial
towards the bottom of the housing
FRX100 VA R Housing Instruction Manual
20
If inserting a silica gel pack inside the housing in order to prevent moisture, it is best to insert it
, in the slot midway up between the two rubber shock absorber
where it doesn’t interfere with proper housing operation. It is important to make sure
that the silica gel pack doesn’t stick out, or else it might interfere with the water
If making use of the Vacuum System, make sure it is fully charged and turn it on prior to closing
the housing (see section “Hybrid Vacuum Safety System”).
Turn the housing Control Dial till the
Auto
g mode symbol is positioned at the
). Make sure not to accidently
turn this control any further before closing
If making use of the Hybrid Vacuum Safety
System, turn the vacuum system on using the power switch on the Signal Board prior to closing
ng (see section “Hybrid Vacuum Safety System”).
small red tab located on the latch is pointed towards the front side
Carefully close the back door of the housing, pushing it against the front door
there is nothing sticking out of the housing or impairing the smooth closure of the back door
Then firmly press the back door against the forward section of the housing.
Turn the secure dial clockwise till the lock dial clicks. The small red tab should then be pointed
towards the bottom of the housing (image #17).
Image #16
Instruction Manual 20200225
If inserting a silica gel pack inside the housing in order to prevent moisture, it is best to insert it
rubber shock absorber
where it doesn’t interfere with proper housing operation. It is important to make sure
that the silica gel pack doesn’t stick out, or else it might interfere with the watertight seal of the
If making use of the Vacuum System, make sure it is fully charged and turn it on prior to closing
System, turn the vacuum system on using the power switch on the Signal Board prior to closing
is pointed towards the front side
Carefully close the back door of the housing, pushing it against the front door, while making sure
there is nothing sticking out of the housing or impairing the smooth closure of the back door.
should then be pointed
Image #15
Image #17
