INSTALLING THE CAMERA
Since the
FRX100 VA R Housing
is specifically design
digital cameras, installing the camera
1.
Make sure the camera is turned off
2.
Hold the camera parallel to the housing and then gently install it inside (image #
inserting one side of the camera prior to the other, as this will make the installation difficult and
might cause damage to the camera or housing.
3.
Take special care not to touch or damage the
camera. The board is located inside the housing
opposite the latch dial (image #
FRX100 VA R Housing Instruction Manual
19
specifically designed for the
Sony RX100 V, RX100 IV
the camera in the housing is quite simple.
Make sure the camera is turned off.
Hold the camera parallel to the housing and then gently install it inside (image #
ng one side of the camera prior to the other, as this will make the installation difficult and
might cause damage to the camera or housing.
ake special care not to touch or damage the Vacuum System signal board when installing the
cated inside the housing on the inner right side of the housing
atch dial (image #14).
SIGNAL BOARD
Image #1
Image #1
Instruction Manual 20200225
V, RX100 IV
and
RX100 III
Hold the camera parallel to the housing and then gently install it inside (image #13). Avoid
ng one side of the camera prior to the other, as this will make the installation difficult and
when installing the
right side of the housing,
13
14
