the inside.
6.
Using your second hand, install the plastic
small needle nose pliers, hold the
the housing backdoor and the
push the C-shaped washer against the shaft until it snaps
7.
Finally, re-install the black rubber
until it is fully and securely seated.
protruding points at the end of the black plastic 2
8.
Once complete, install the camera inside the housing and test to control. If properly installed,
the control should work smoothly when turned or pushed against the camera button.
9.
The C-shaped washer should remain in this position as long as the housing is used to
accommodate the RX100 III camera.
or RX100 V camera, the C-shaped washer
Important Notice: This procedure should only be followed if using the housing to accommodate the
RX100 III camera. Installing the C-shaped washer
RX100 V camera will interfere with housing functionality and potentially damage the camera
and/or housing!
Image #
FRX100 VA R Housing Instruction Manual
18
Using your second hand, install the plastic C-shaped washer on the control shaft. First, using
, hold the C-shaped washer against the shaft so it’s position
and the black plastic 2 pointed seat installed at the end of the shaft. Then
against the shaft until it snaps securely into place (image #1
rubber disc at the end of the control by pushing it against the shaft
seated. Do so by mounting the 2 holes on the disc center onto the 2
the end of the black plastic 2-pointed seat.
ll the camera inside the housing and test to control. If properly installed,
the control should work smoothly when turned or pushed against the camera button.
should remain in this position as long as the housing is used to
e the RX100 III camera. In case of using the housing to accommodate the RX100 IV
shaped washer should be removed.
Important Notice: This procedure should only be followed if using the housing to accommodate the
shaped washer when using the housing with the RX100 IV
camera will interfere with housing functionality and potentially damage the camera
Image #11
Housing
backdoor
Black plastic 2-
pointed seat at
end of shaft
C-shaped
washer
Instruction Manual 20200225
shaft. First, using
against the shaft so it’s positioned between
installed at the end of the shaft. Then
(image #12).
at the end of the control by pushing it against the shaft
by mounting the 2 holes on the disc center onto the 2
ll the camera inside the housing and test to control. If properly installed,
the control should work smoothly when turned or pushed against the camera button.
should remain in this position as long as the housing is used to
case of using the housing to accommodate the RX100 IV
Important Notice: This procedure should only be followed if using the housing to accommodate the
when using the housing with the RX100 IV /
camera will interfere with housing functionality and potentially damage the camera
Image #12
