CLOSING THE HOUSING
1.
If making use of the Hybrid Vacuum Safety System, turn the vacuum system on using the power
switch on the Signal Board prior to closing the housing
System”).
2.
Turn the latch dial so that the small red tab located on
of the housing (image #12).
3.
Carefully close the back door of the housing, pushing it against the front door
there is nothing sticking out of the housing or impairing the smooth closure of the back door
Then firmly press the back door against the forward section of the housing.
4.
Turn the secure dial clockwise till the lock dial
towards the bottom of the housing
5.
Gently try pulling the back door awa
be impossible to open the back door.
6.
Visually inspect the black O-ring
sure it isn’t twisted or out of the groove and that no fo
such as secure lines, sand, grit, hairs or any other foreign substance.
FG7X III R Housing Instruction Manual
18
If making use of the Hybrid Vacuum Safety System, turn the vacuum system on using the power
prior to closing the housing (see section “Hybrid Vacuum Safety
small red tab located on the latch is pointed towards the fro
Carefully close the back door of the housing, pushing it against the front door
there is nothing sticking out of the housing or impairing the smooth closure of the back door
door against the forward section of the housing.
Turn the secure dial clockwise till the lock dial clicks. The small red tab should then be pointed
towards the bottom of the housing (image #13).
Gently try pulling the back door away from the front door. If the housing is properly closed, it should
be impossible to open the back door.
ring through the transparent back door for proper closure.
sure it isn’t twisted or out of the groove and that no foreign matter has been caught in the seal
sand, grit, hairs or any other foreign substance.
Image #12
Instruction Manual 20200220
If making use of the Hybrid Vacuum Safety System, turn the vacuum system on using the power
(see section “Hybrid Vacuum Safety
is pointed towards the front side
Carefully close the back door of the housing, pushing it against the front door, while making sure
there is nothing sticking out of the housing or impairing the smooth closure of the back door.
should then be pointed
y from the front door. If the housing is properly closed, it should
for proper closure. Make
reign matter has been caught in the seal,
Image #13
