b.
Red flashing – The housing failed the check. Inspect the housing for potentia
sources. If failing to find the source, it is recommended to reinstall and lock all system
components, visually inspect all o
watertight seal of the housing.
11.
If during the analysis the LED Indicator
analysis has been interrupted by over
steps below to allow the analysis to properly continue:
a.
Yellow flashing - Use the Vacuum Pump to extra
steady yellow.
b.
Red and Green flashing
counterclockwise and pulling it out (image #
yellow.
12.
In case of a significant air leakage detected anytime during the process, the LED Indicator will
turn flashing red.
Pre-Dive Check LED Indicator Diagram
13.
Once the pre-dive check is complete and the
a.
Reinstall the Protective Cap over the Vacuum Valve if it hasn’t been reinstalled yet. Note
that the Vacuum Valve is watertight even without the Protective Cap, as long as the
Vacuum Release Tip isn’t pulled out during the dive. However, the Protective Cap ensures
Flashing
Yellow
Steady
Yellow
Continue
Pumping
4-min. Vacuum
Analysis in progress
Flashing Green =
Housing ready to
dive
FG7X III R Housing Instruction Manual
26
The housing failed the check. Inspect the housing for potentia
sources. If failing to find the source, it is recommended to reinstall and lock all system
components, visually inspect all o-rings and make sure nothing interferes with the
watertight seal of the housing.
If during the analysis the LED Indicator starts flashing in yellow or alternately red and green, the
analysis has been interrupted by over-pressure or under-pressure correspondingly. Follow the
steps below to allow the analysis to properly continue:
Use the Vacuum Pump to extract air again until the LED indicator turns
Red and Green flashing - Release a bit of the vacuum by turning the Vacuum Release Tip
counterclockwise and pulling it out (image #21) until the LED Indicator turns steady
ficant air leakage detected anytime during the process, the LED Indicator will
Dive Check LED Indicator Diagram
dive check is complete and the watertight seal of the housing has been confirmed:
einstall the Protective Cap over the Vacuum Valve if it hasn’t been reinstalled yet. Note
that the Vacuum Valve is watertight even without the Protective Cap, as long as the
isn’t pulled out during the dive. However, the Protective Cap ensures
Flashing
Red/Yellow
Steady
Yellow
min. Vacuum
Analysis in progress
Release Vacuum
with Valve Lock
Inspect housing
Flashing Red =
Housing Failed
Check
Instruction Manual 20200220
The housing failed the check. Inspect the housing for potential leakage
sources. If failing to find the source, it is recommended to reinstall and lock all system
rings and make sure nothing interferes with the
starts flashing in yellow or alternately red and green, the
pressure correspondingly. Follow the
ct air again until the LED indicator turns
Release a bit of the vacuum by turning the Vacuum Release Tip
) until the LED Indicator turns steady
ficant air leakage detected anytime during the process, the LED Indicator will
watertight seal of the housing has been confirmed:
einstall the Protective Cap over the Vacuum Valve if it hasn’t been reinstalled yet. Note
that the Vacuum Valve is watertight even without the Protective Cap, as long as the
isn’t pulled out during the dive. However, the Protective Cap ensures
Flashing
Red
Inspect housing
for source of
leakage
