FANOX SIL-V, User Manual, Page: 87 / 212

www.fanox.com Rev.10 87/212
Line-Bar voltage difference:4 to 50 V (step 0.1 V)
Line-Bar phase difference: 2 to 90 °(step 0.1 °)
Line-Bar frequency difference: 0.06 to 10 Hz (step 0.01 Hz)
Synchro temporization: 0.02 to 300 s (step 0.01 s)
Phase B line voltage and busbar voltage. Modules and phases using DFT
- Frequency using hardware circuit with the passing through zero detection.
Permission signal minimum time 150 ms
49T
Available through configurable inputs
Programmable logic
control (PLC)
OR4, OR4_LATCH, OR4_PULSES, OR4_TIMERUP, OR4_PULSE, NOR4, NOR4_LATCH,
NOR4_TIMERUP, NOR4_PULSE, AND4, AND4_PULSES, AND4_TIMERUP, AND4_PULSE,
NAND4, NAND4_TIMERUP, NAND4_PULSE
86
Allows to latch (lock out) the contact trip due to programmable logic (PLC: OR_LATCH).
Settings tables 3 settings tables
Activated by general settings or by inputs
RTC Capacitor charge time: 10 minutes
Operation without auxiliary voltage: 72 hours
Oscillography 16 samples/cycle
Oscillo starting configuration
5 records: 3 cycles pre-fault and 85 post-fault
COMTRADE IEEE C37.111-1991
4 analogue channels and 64 digital channels
Fault report 20 fault reports with 24 events in each
Configurable inputs 6 configurable inputs.
The voltage of the inputs is the same as the auxiliary power supply
Configurable outputs 4 configurable outputs:
250 V AC
– 8 A
30 V DC
– 5 A
Output 1 and output 2: Commuted ( NC + NO)
Output 3 and Output 4: NO
Frequency 50/60Hz
Voltage measurement Phase voltages (V-A, V-B, V-C), calculated neutral voltage (3V-0), residual voltage (V-R) (*), Busbar
voltage (V-BB)(*), positive sequence voltage (V-1), negative sequence voltage (V-2), Maximum
voltage (Vmax) and Minimum voltage (Vmin)
Measurement range:
Low scale (rated voltage<250 V)

3-250 V
High scale (rated voltage>250V)

12-1000 V