8
How to Assemble Your Ceiling Fan (continued)
7.
Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 7)
Figure 7
8.
Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 8)
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
5.
Route wires and safety cable
through motor
coupling cover, canopy screw cover and
ceiling canopy. (Figure 5)
Figure 8
Hanger Bracket
Figure 5
Motor Coupling
Cover
Ceiling Canopy
Canopy Screw
Cover
6.
Reinstall the hanger ball on the downrod as follows.
Route the black, white, blue wires
and safety cable
through the hanger ball. Position the pin through the
two holes in the downrod and align the hanger ball
so the pin is captured in the groove in the top of the
hanger ball. Pull the hanger ball up tight against the
pin. Securely tighten the set screw in the hanger ball.
A loose set screw could create fan wobble. (Figure 6)
Figure 6
