REMOTE CONTROLLER INSTRUCTIONS
12
Rev 3.0
Fanco Infinity DC. All Rights Reserved.
Install Battery:
Open battery cover by pressing down and sliding the cover. Install two 1.5V (AAA) batteries
(included) into the hand held remote transmitter battery compartment. (if not use for long period
of time, remove the batteries to prevent damage to the transmitter).
SET
ID Code Pairing:
Press the SET button and Number 4 button together for over 5 seconds to initiate the code
learning process between the handset and the receiver.
NOTE: This button is only functional when press with number 4 button.
F / R
Fan Reversing:
Press this button on the remote controller handset to toggle between SUMMER and WINTER
settings. The fan should ideally be set to move blades in anticlockwise direction for downwards
airflow during summer seasons, and to move blades in clockwise direction for upwards airflow
during cooler seasons.
Light ON/OFF:
Press the button once to toggle the fan light to ON or OFF.
By default, light is ON after power to the fan is turned ON.
NOTE: This button is only functional on remote handset for ceiling fan equipped with light. The
button is NOT functional on remote handset for ceiling fan WITHOUT light.
OFF
Fan OFF and SPEED CHANGE
:
Press the OFF button once to turn OFF the fan.
By default, fan is OFF after power to the fan is turned ON.
Press buttons with numbers (1, 2, 3, 4, 5, and 6) to turn ON the fan at the corresponding speed
setting. Speed 1 is the lowest speed. Lower fan speeds consume considerably less power than
higher fan speeds. Operate ceiling fan at a lower speed to generate comfortable wind for a
restful sleep.
