20
If you go to the PC driver page ‘Settings’ you will see this window:
There are two different slider bars in the section ‘Steering wheel’:
The upper bar ‘Wheel angle’ can adjust the maximum turning angle of the Club-
Sport Wheel Base V2, so the functionality is identical with the option ‘SEN’
in tuning menu (see chapter ‘Tuning Menu’ of this manual for more detailed
information). Please note that in tuning menu the value for ‘SEN’ must be set
to ‘OFF/Aut’ to allow the PC driver to take the control. If in tuning menu ‘SEN’
is set to any other value than ‘OFF/Aut’ the value set in tuning menu is applied
and valid and the PC driver has no influence.
The lower bar ‘Dampering strength’ is an additional fine tuning possibility for the
tuning menu option ‘DPR’ (see chapter ‘Tuning Menu’ of this manual for more
detailed information).
In section ‘Pedals’ there is only the one checkbox called ‘Combined pedals’. Ac-
tivate this checkbox if the game or software uses only one input (I/O) for brake
and throttle pedal signals (negative signal for brake, positive signal for throttle).
This might solve problems especially with older games.
In section ‘Gear shifts’ there is only one checkbox called ‘Map sequential shift-
er to the shifter paddles’. Usually shifters connected to the SHIFTER2 port
are mapped to different inputs (I/Os) than the shifter paddles at the Fanatec
Steering Wheels. If you want to change the mapping so that the used inputs for
these shifters are identically mapped as for the Fanatec Steering Wheel shifter
paddles activate this checkbox. This might be a good option when using the
ClubSport Static Shifter Paddles (CS SSP).
