Famco MONT72 Series, User Manual

Page: 70 / 113

Shenzhen Hpmont Technology Co., Ltd. Chapter 6 Function Introduction
MONT72 Series User Manual V1.0 - 61 -
6.2.12 F11: PG Parameters
In elevator application, the PG is necessary for the motor. Please refer to section 4.5 for PG.
Ref. Code Function Description Setting Range [Default]
F11.00 MONT72 PG interface board 1 - 4 [1]
1: HD-PG2-OC-FD is valid. Only for asyn. motor.
2: HD-PG6-UVW-FD is valid. Only for syn. motor.
3: HD-PG5-SINCOS-FD is valid. Only for syn. motor.
4: HD5L-PG1-SC is valid. Only for syn. motor. (support Endat)
F11.01 PG P/R 1 - 9999 [2048]
F11.02 PG direction setting 0,1 [0]
Defines the connection sequence of PG whether the same as that of the drive-motor connection.
•
In order to change the connection of AB two phases of the PG, you can change this parameter.
0: The same direction.
1: The reverse direction.
F11.03 PG signal filter coefficient 0x00 - 0x77 [0x11]
Unit: Low-speed filter coefficient.
Ten: High-speed filter coefficient.
F11.04 The protocol of serial communication PG 0 - 9 [0]
0: Endat.
1 - 9: Reserved.
F11.05 Detecting time of PG wire disconnection 0.00 - 2.00 [1.00s]
F11.05 specifies the duration time for detecting PG wire disconnection fault.
MONT72 detects the PG wire disconnection and the duration time exceeds F11.05, then the controller
reports E0031 fault (PG disconnection).
•
No detection will be conducted when F11.05 = 0.
6.2.13 F12: Digital I/O Terminal Parameters
Ref. Code Function Description Setting Range [Default]
F12.00 Input terminal filter time 0.000 - 1.000 [0.010s]
Defines filter time of digital input terminal and to set input terminal sensibility.
•
The input terminals are susceptible to interference which will result in misoperation, so F12.00 can be
increased. But too long filter time will affect sensibility.
F12.01 X1 terminal function 000 - 134 [1]
F12.02 X2 terminal function 000 - 134 [2]
F12.03 X3 terminal function 000 - 134 [3]
F12.04 X4 terminal function 000 - 134 [4]
F12.05 X5 terminal function 000 - 134 [5]
F12.06 X6 terminal function 000 - 134 [6]
F12.07 X7 terminal function 000 - 134 [0]
F12.08 X8 terminal function 000 - 134 [0]
F12.09 X9 terminal function 000 - 134 [0]
F12.10 X10 terminal function 000 - 134 [0]
6