Famco MONT72 Series, User Manual

Page: 46 / 113

Shenzhen Hpmont Technology Co., Ltd. Chapter 5 Operation Instructions
MONT72 Series User Manual V1.0 - 37 -
5.2 LCD Keypad
MONT72 LCD keypad.
Buttons Functions
Entry or exit programming key
a. Enter lower menu
b. Confirm saving the data
In the keypad control, press this key to run MONT72
a. In the keypad control, press this key to stop MONT72
b. In the detection fault, press this key to reset at fault
Increase value or parameter
Decrease value or parameter
a. Select the modification bit of the setting data
b. Cycle switch stop / run display status parameter
Select the modification bit of the setting data
5.2.1 Display Description
Power on display interface
When the keypad is powered on, the display interface is as shown in Figure 5-1.
After the “Power-on Display Interface” is displayed on keypad, if the MONT72 does not set the user
password, the “Status Display Interface” is displayed; If the user password is set, the “Enter Password
Display Interface” is displayed.
Figure 5-1 Power-on display
Password entering interface
When the MONT72 is configured with parameter password
protection, you must enter the correct password to perform the
operation of the keypad.
When the MONT72 is powered on or the keypad has no button
operation within 5 minutes, the keypad displays “Enter Password
Display Interface”, as shown in Figure 5-2.
User password clearing, modification, setting, see section 5.2.3.
Figure 5-2 Enter the password
display interface
Note:
If the MONT72 is not set with password protection, the “Enter Password Display Interface” does not appear
when the power is turned on.
Digital Operator
ENT PRG
STOP RUN
Rated power
:
11. 0 KW
Rated current
:
27. 0 A
Software version V1.01
Elevator dedicated
controller
【
Enter password
】
0 0 0 0 0
5