millibars
Inch WG
millibars
Inch WG
Low/
turndown
3.5
1.4
9
3.6
A spring loaded governor supplied with the appliance, MUST BE FITTED to Natural gas (I
2
h) models.
No governor is to be fitted on Propane (I3p) models.
A pressure test point is accessible upon removal of the side panel.
The Low/ turndown adjustment screw is located on the gas control, under the control knob spindle.
1.10 Burner Adjustment
Burner Aeration
The burners are fitted with fixed injectors. Aeration is adjustable by means of a screw, positioned at
the burner inlet.
After setting pressure, the stability of the flame cones should be checked. If necessary, the aeration
screw should be adjusted to achieve satisfactory cross lighting of burners on both HIGH and LOW
settings. This will also prevent yellow tipping of the flame or lift-off.
SECTION 2
– ASSEMBLY AND COMMISSIONING
2.1
Assembly
2.1.1 Grill Unit
Unpack grill and check that all components are undamaged. Parts supplied loose are specified in the
contents list below.
Brander Drip Trough
Brander Plate
Grid Shelf
Drip Tray
Gas Governor (Natural Gas only)
Additionally, the necessary plaques, supports and cross-lighting burners are supplied as follows:-
Model
Plaques
Centre
Point
End
Support
X-Lighting
Burner
G2522
12
6
4
2
2.1.2 Appliance Mounting Accessories
Details of various mounting options can be obtained by contacting Falcon Sales, distributor or place of
purchase.
Refer to the individual instructions supplied with the individual means of mounting.
Adherence to positioning clearances indicated in Section 1.2 of this manual is mandatory.
2.1.3 Assembly of Support Bars and Plaques
a) When unit has been installed in desired location, the centre support bars can be positioned
between the burner lugs. Similarly LH and RH plaque supports are located between burner lugs
and support angle. See Figure 1 below.
b) With support bars in position, plaques may be inserted by placing these upon bars as illustrated
below.
