English
34
Pressure testing
The gas pressure can be measured at the injector of one of
the centre hotplate burners. Remove the pan support, burner
head and cap. The injector is now accessible.
See Technical data section at the back of this book for test
pressures.
Reassemble burner top, making sure it is reassembled in the
correct way on the burner body.
Electrical Connection
This appliance must be installed by a qualified electrician
to comply with the relevant regulations and also the local
electricity supply company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note
The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
a suitable cooker control unit incorporating a double pole
switch having a contact separation of at least 3mm in all
poles. This cooker must not be connected to an ordinary
domestic power point.
The total electrical load of the appliance is approximately
7.2kW. The cable size used should be suitable for this load and
comply with all local requirements.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel.
Connect the mains cable to the correct terminals for your
electrical supply type.
Check that the links are correctly fitted and that the terminal
screws are tight. Secure the mains cable using the cable
clamp.
Hotplate
Check each burner in turn. There is a flame safety device that
stops the flow of gas to the burner if the flame goes out. For
each burner, turn the control knob to the large flame symbol.
Press in the control knob. This lets gas through to the burner.
Keep holding the knob pressed in and press the igniter
button or light with a match. Keep holding the control knob
pressed in for about 10 seconds.
If when you let go of the control knob the burner goes out,
the safety device has not held in. Wait one minute then try
again this time holding the control pressed in for slightly
longer.
Grill
Open the grill compartment door. Turn on the grill control
and check that the grill heats up.
Oven check
The clock must be set to the time of day before the ovens will
work.
See the ‘The clock’ section for how to set the time of day.
Turn on the ovens and check that they start to heat up. Turn
off the ovens.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and fit each end keyhole over their respective screws. Tighten
the fixing screws.
Oven Lights
Press the oven light switches and check that the lights are
working.
NB. The oven light bulbs is not included in the guarantee
Customer care
Please inform the user how to operate the cooker and hand
over these instructions.
Thank you.
