Falcon DOMINATOR PLUS Series, Installation And Servicing Instructions

Page: 4 / 12

SECTION 2 - ASSEMBLY and COMMISSIONING
2.1 ASSEMBLY
The appliance is supplied complete and ready to be connected to the mains supply.
Position unit in desired location and level it. Turn lower section of each leg clockwise to raise corresponding
corner height or anti-clockwise to lower it.
Castors
Undo grub screw and use a spanner to adjust the castor height. Turn clockwise to raise level and anti-clockwise to
lower.
Secure grub screw when task is completed.
Grub screw
2.2 CONNECTION TO THE ELECTRICAL SUPPLY
To gain access to terminals, proceed as follows:-
Remove fixings at unit rear to remove cover and access electrical connections.
Undo cable gland.
Feed cable through cable gland into electrical box. Connect leads to respective terminals.
Tighten cable gland. Replace cover.
If single phase connection is required, refer to Section 1.3 for details.
2.3 COMMISSIONING
Fill pan(s) with oil to mark on element guard (i.e. approximately 20 litres for E3830 model and 40 litres for
E3860 & E3865 models) and switch on at isolator switch. Turn thermostat to maximum setting and check that
it operates at the correct temperature of 190°C.
The importance of never switching on the elements unless
they are covered by oil or water must be stressed. DO NOT USE
SOLID FAT.
2.4 INSTRUCTION TO USER
After installing and commissioning appliance, hand user instructions to user or purchaser.
Ensure that person (s) responsible is (are) made familiar with use and maintenance of unit.