FOX3-2G/3G/4G/-4G-PROMOTION-KIT Getting Started
Version 1.0.7
This confidential document is a property of FALCOM GmbH and may not be copied or circulated without previous permission.
Page 23 of 25
6.3
Installing your own SIM card and replacing the internal battery
To insert your own SIM card into the FOX3-2G/3G/4G' SIM holder and replace the internal battery by a new
one, follow the steps represented in figure below:
Figure 14:
Inserting you SIM card and replacing the battery by a new one
For more details refer to the Related Documents
When using your own SIM card and another TCP server, the following table shows the basic configuration
settings that should be done in the FOX3 device to register the device in the GSM network and enable
internet connection to your TCP-Server. These configuration settings should be done locally via serial port
connection. After inserting your SIM card and powering up the device, send the following commands
(marked in red) from Workbench
Editor
➒
(see Fig. 8) to the FOX3-2G/3G/4G
.
SETUP
$PFAL,Cnf.Set,GPRS.APN=internet.t-d1.de (enter your provider's APN)
$PFAL,Cnf.Set,GPRS.QOS=3,4,3,0,0
$PFAL,Cnf.Set,GPRS.QOSMIN=0,0,0,0,0
$PFAL,Cnf.Set,PPP.USERNAME=t-d1 (if your provider requires)
$PFAL,Cnf.Set,PPP.PASSWORD=gprs (if your provider requires)
Settings required for a GPRS attachment
SETUP
$PFAL,Cnf.Set,TCP.CLIENT.CONNECT=1,2222.222.222.222,1111 (enter your IP and Port)
Settings required for a TCP connection.
Where: 2222.222.222.222 - is the IP-address of the TCP server to be connected;
1111 - is the TCP port number of the TCP server to be connected;
$PFAL,CNF.Set,TCP.CLIENT.LOGIN=1
Sends the login data automatically to the remote server after requesting the TCP server for
establishing a connection.
SETUP
$PFAL,Cnf.Set,GPRS.AUTOSTART=1 (default = 0)
Activate GPRS autostart to reconnect automatically when GPRS network connection gets lost.
SETUP
$PFAL,Cnf.Set,DEVICE.PIN=1111
(enter the PIN of the used SIM card)
Enter the SIM PIN to register the FOX3 device into the GSM network:
Where: 1111 - is the PIN of the inserted SIM card.
Table 11:
Adapt device configuration settings to your application conditions (mandatory settings).
