DRAFT
16
How To Charge Battery :
We always recommend to always charge your battery after a ride (if level of charge is
less than a half).
Recharge at ambient temperature.
Avoid warm Locations.
You can either remove the battery or connect the battery directly on your bicycle.
Then plug the battery pack cord into a standard wall outlet (110 Volts or 220 Volts)
A fully discharged battery can be recharged in approximately 3 to 4 hours.
Always turn off your system before plugging the charge or before removing the
battery to recharge. Never turn on/off the system while the battery is charging.
Let the battery get back to room temperature (20°C) before recharging it.
NOTE: Since the battery does not have a memory. It is not necessary to complete discharge
the battery before charging it again.
Before Any ride:
Make sure the connections are all correctly plugged in;
Look for a full battery charge level on your LCD command console. If this is not the
case, please refer to the “ how to charge the battery” section ;
Always make sure your battery is well fastened to the frame and locked.
Flat Tire :
Disconnect Metric pack battery connector that connects the battery to motor.
Remove wireless & crank sensor connection from the Hx motor.
You can remove Falco e-motors wheel like any often conventional wheel.
In case of problem please see your retailer
.
How To Bring The Best Out Of Your FALCO e-Motors System :
Use Cruise, Turbo & Eco mode according to requirements. Always remember that
your Falco e-motor is still a bicycle & should be used as such
.
DON’T throw Battery in household dustbin.
USED battery must be disposed properly
.
Page 16 of 18
Rev. 0 March 23, 2013
