16- ENG
AWSC
= Authorized Warranty Service Center
PRESSURE WASHER
1.
Drain all water from high pres-
sure hose,
coil it, and store it
in cradle of the pressure washer
handle.
2.
Drain all water from spray gun
and wand
by holding spray gun in
a vertical position with nozzle end
pointing down and squeezing trig-
ger. Store in gun holder.
3.
Store chemical hose so it is pro-
tected from damage.
TROUBLE SHOOTING GUIDE
PROBLEM
CAUSE
CORRECTION
Engine will
not start (see
Engine Manual
for further
engine
troubleshoot-
ing)
No fuel.
Add Fuel.
Pressure builds up after two
pulls on the recoil starter or
after initial use.
Squeeze gun trigger to relieve
pressure.
Choke lever in the "No Choke"
position.
Move choke to the "Choke"
position.
Spark plug wire not attached.
Attach spark plug wire.
Engine switch in OFF
position.
Place engine switch in on posi-
tion.
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat for a
long period of time.
Move choke to the "No Choke"
position.
No or low
pressure
(initial use)
Spray wand not in high pres-
sure.
See How to
Use Spray Wand
instructions in the
Operation
Section.
Low water supply.
Water supply must be at least
5 GPM @ 20 psi.
Leak at high pressure hose
fitting.
Repair leak. Apply sealant tape
if necessary.
Nozzle obstructed.
See
Nozzle Cleaning
instruc-
tions in the
Maintenance
sec-
tion.
Water filter screen clogged.
Remove and clean filter.
