Fagor TE-290-TE-291, Instructions For Use Manual

Page: 8 / 30

7
bread, the quality of the bread and the
thickness of the slices.
• The toast darkness must be selected
before switching on the toaster.
4. FUNCTIONING
• Stand the toaster on an even, heat-
resistant surface.
• Before using the toaster, check there are
no objects the slots.
• Switch the toaster on for the first time
with no bread in the slots, as described
below, turning the browning dial to its
highest position, in order to eliminate any
residual manufacturing oil.
• Place the slices of bread in the slots.
• Select the toast darkness on the dial.
• Plug the toaster in.
• Press the toast lever down until it is
retained at the bottom of the toaster. The
toasting cycle will then begin.
• When the toasting cycle ends, the bread
will pop up automatically and the toaster
will switch off. If you wish to toast more
bread, wait 1 or 2 minutes before using
the toaster again.
• If you wish to remove the bread before
the toasting cycle finishes, press the stop
button. The bread will automatically pop
up and the toaster will switch off.
• When you finish using the toaster, unplug
it and wait for it to cool down before
putting it away.
Important: If a slice of bread becomes
stuck in the toaster, proceed as follows:
• Unplug the toaster and wait for it to cool
down.
• Then carefully remove the bread. Do not
use metal or sharp objects.
• Do not try to remove the bread while the
toaster is functioning.
5. CLEANING
Before cleaning the toaster, unplug it and
wait for it to cool down.
Wipe the outside of the toaster with a damp
cloth. Do not submerge it in water or place it
under the tap.
Do not use solvents or abrasive products to
clean the toaster.
To remove crumbs, pull out the crumb tray.
Avoid touching the metal edges of the
crumb tray. Clean it and replace it in its slot.
6. WASTE ELIMINATION
The materials used in the
packaging, product and
accessories can be recycled.
Correct separation of waste
materials will allow recyclable
materials to be re-used.
When the appliance is no longer useful, you
should cut its cord to put it out of action and
dispose of it using a suitable waste
elimination procedure. For further
information on this matter, consult your local
authorities.
interior 4/6/04 09:01 Página 6