EN
14
4/USING YOUR APPLIANCE
Power
Application
1000 W / 900 W
Rapidly heating drinks, water, dishes containing a lot of water.
Cooking foods containing a lot of water (soups, sauces,
tomatoes, etc.).
800 W / 700 W
Cooking fresh or frozen vegetables.
600 W
Melting chocolate.
500 W
Cooking fish and shellfish. Reheating on 2 levels.
Simmering pulses. Heating or cooking delicate egg-based foods.
400 W / 300 W
Simmering dairy products, jams.
200 W
Manual defrosting. Softening butter, ice cream.
100 W
Defrosting pastries containing cream.
MICROWAVE POWER RESTORED: 1000 W
Your appliance is now connected and displaying the correct time.
Open the door using the handle. Place the food in the appliance and close the door.
If the door is not closed the appliance will not function properly.
If the door is opened during operation, the programming is not cancelled but simply interrupted.
To start the oven again after closing the door, simply press the start key .
If no action is taken in the following minute, 3 beeps are heard requesting you start up the pro-
gramme. A minute later the programme is cancelled.
At the end of a programme when the appliance stops the time is displayed again. Three beeps indi-
cate the end of the programme. This signal is repeated once a minute for 10 minutes until the door
is opened. The beep may be stopped by pressing the start/stop key .
In order to evacuate any steam remaining in the oven, your appliance is fitted with a post venti-
lation function. The oven ventilation will continue to operate for 15 minutes after the end of the
programme, until the door is opened.
To cancel a programme, turn the selector to the “0” position, press the start/stop key
for
two seconds or open the door and press stop .
If you think that the size of the dish is preventing the turntable from turning, use the
STOP
TURNTABLE
function before or during a programme.
To set this function, press the
key at any time. A beep confirms that it is set.
The
symbol lights up and the turntable stops. To cancel the function, follow the same pro-
cedure. It is necessary to turn the container or stir the contents halfway through the programme
when the turntable is stopped. If there is a programming error, press the
START/STOP
key, the
programming will be cancelled.
•
PROGRAMMING
•
USING THE POWER LEVELS
