15
7
TROUBLESHOOTING
First be sure that the “Installation Checklist” in this manual was completed and check out that all
the items still remains in effect. For support or further service information contact Fagor Service
Department toll free at 1-866-GO-FAGOR (46-32467). The diagnosing, testing and repair of any
electrical, mechanical device is to be performed solely by trained service technicians
.
SYMPTOM
POSSIBLE CAUSE
ACTION
Service breaker tripped
Reset. If the breaker trips again, contact an
electrician to verify amps or possible short.
Machine not connected to
power source.
Verify the unit is connected to a hot (live)
feed. Verify voltage and proper phasing.
Faulty selector switch (Ig) Verify the wiring of the switch; if correct,
replace the switch. (Position 1-1a / 2-2a)
Dishwasher will NOT
FILL after the door is
closed. Selector in
∇
position, light is
not
illuminated
.
Fuses blown up
Check out fuses. Replace if neccessary.
No water to machine
Verify hose is not blocked or kinked, water
valve is open and pressure > 20 PSI.
Overflow tube not
attached or broken /
missing O-ring.
Check condition of overflow tube.
Faulty door switch
Verify the wiring of the switch; if correct,
replace the switch (Ip) or the door relay
(Cp)
Dishwasher will NOT
FILL after the door is
closed. Selector in
preparation (
∇
) position.
Power “ON” light (L1)
is illuminated.
Faulty fill valve (VA)
Verify the wiring and voltage received; if
correct replace fill valve.
Fill pressure switch’s pipe
clogged
Drain the unit and fill again
Faulty fill pressure switch
(P12)
Verify position change 1-2 / 1-3 to
pressure switch. Possibly stuck
Faulty door switch
Verify the wiring of the switch; if correct,
replace the switch (Ip) or the door relay
(Cp)
Faulty selector switch (Ig) Verify the wiring of the switch; if correct,
replace the switch. (Position 3-3a / 4-4a)
Faulty motor relay
(CMV1/CMV2)
Ohm out relay, closed when solenoid
receiving voltage. If not replace .
Dishwasher will NOT
RUN after the door is
closed. Selector in
advance position,
Power “ON” light (L1)
is illuminated.
,
the unit
has completed the filling
and heating cycle.
Faulty motor (MV1/MV2)
Verify the wiring and voltage received;
Replace if necessary.
Faulty selector switch (Ig) Verify the wiring of the switch; if correct,
replace the switch. (Position 5-5a)
Faulty washing switch
(IL)
Verify it changes position of the switch; If
not replace it.
Dishwasher will NOT
WASH after the door is
closed. Selector in
advance position, Power
“ON” light (L1) is
illuminated
,
the unit has
Faulty wash pump relay
(CMBL)
Ohm out relay, closed when solenoid
receiving voltage. If not replace .
