Fagor FDO900X, User Manual

Page: 9 / 26

9
HOW TO INSTALL YOUR OVEN
• •
— — The power cable (H05 RR-F, H05 RN-F or H05 VV-F) must be of sufficient length to be con-
nected to the build-in oven while it sits on the floor in front of the cabinet.
To do this the appliance must be disconnected from the electrical network:
—
— Open the inspection flap located at the lower right of the back cover by unscrewing the
two screws, then pivot the inspection flap.
—
— Strip 12 mm along each wire of the new power cable.
—
— Carefully twist the strands together.
—
— Loosen the screws from the terminal board and remove the power cord to be replaced.
—
— Insert the power cable through the side of the cover into the cable clip located to the right
of the terminal board.
—
— All the strands of the electrical wires must be secured tightly under the screws.
— The phase wire on the L terminal.
— The green-yellow coloured earth wire should be connected to the terminal .
— — The neutral wire (blue) on the N terminal.
---- Connect the wires according to the table (on previous page).
—
— Screw down tightly the screws on the terminal board and check the connection by pulling on
each wire.
—
— Attach the cable with the cable clip located to the right of the terminal board.
—
— Close the inspection flap using the two screws.
1st CONNECTION OR CHANGE OF THE POWER CABLE