Fagor Eco Concept CCO-120, Service Manual

Page: 46 / 79

02/05/2020 45
SERVICE MANUAL
CONVEYOR BELT
DISHWASHERS
•
IMPORTANT! In all Compact models (CCO-120, CCO-160, CCO-120 ECO and CCO-160 ECO) and
in the right-hand Modular models (CCO-180, CCO-225, CCO-270, CCO-320, CCO-180 ECO, CCO-
225 ECO, CCO-270 ECO, CCO-320 ECO) rotation should be clockwise. In the left-hand modular
models (CCO-180, CCO-225, CCO-270, CCO-320, CCO-180 ECO, CCO-225 ECO, CCO-270 ECO,
CCO-320 ECO), rotation should be anticlockwise.
• IMPORTANT! Check that the dryer fan and the energy recovery fan rotate in the correct direction.
The dryer fan must be able to open the dryer air output cover and the energy recovery fan must
extract air. If both fans are not operating correctly, change the two phases of the electrical supply
cable.
24.2. CONFIGURATION OF HEATING TEMPERATURES
The heating temperatures of the tank and the boiler can be configured using the digital thermometers WASH TEMP
and RINSE TEMP .
The preconfigured and nominal recommended temperatures are 85 ºC in the boiler and 62 ºC in the tank. If these
values are changes, adequate wash and/or rinse temperatures cannot be guaranteed.
If one of the digital thermometers is replaced, the nominal heating value must be configured.
The digital thermometers permit the configuration of temperatures within the following ranges:
RINSE TEMP

Boiler: Temp range between 70 and 85 ºC (Not available in ECO models).
WASH TEMP

Tank: Temp range between 50 and 65 ºC.
The procedure for changing the temperature parameters is as follows:
1
When the appliance is switched on, the keys
on the electronic thermometers are unlocked.
They lock automatically after 30 seconds of
inactivity.
To unlock the keypad, press SET for several
seconds. When this is pressed, Loc (Locked)
is displayed, when the keypad is unlocked this
changes to UnL (Unlocked).
2
After unlocking the thermometer keypad, the true temperature continues
to be displayed.
Press SET once and the thermometer enters the temperature range
configuration: the default temperature is displayed and the upper left
green icon flashes.
3
Use the
˄
and
˅
, buttons to increase or lower the nominal heating
temperature configured, within the ranges specified above.
RINSE TEMP

Boiler: Temp range between 70 ºC and 85 ºC
WASH TEMP

Tank: Temp range between 50 ºC and 65 ºC